5、菱 Temperature Control -Temperature Control 模块 用户手册
When disconnecting a cable without a connector, first loosen the screws on the part that is
connected to the module.
Pulling the cable when it is still connected to the module may cause damag
6、 Temperature Control -Temperature Control 模块 用户手册 (硬件)
Conformance to the EMC Directive/Low Voltage Directive
When Mitsubishi programmable controller conforming to the EMC
Directive/Low Voltage Directive is mounted into your product and t
7、 Temperature Control -Temperature Control 模块 用户 手册 (硬件)
failure.
Always ground the shielded cable for the programmable controller.
There is a risk of electric shock or malfunction.
When wiring, be sure to verify the rated voltage of the produc
8、 SW2SRX -SW2SRX-GSV13PE 操作 手册
CAUTION
Use wires and cables within the length of the range described in the instruction manual.
The ratings and characteristics of the system parts (other than control unit, servo amplifier,
9、 SV1322 -SV1322(REAL MODE) Programming 手册
A - 2
! CAUTION
Install the Motion controller, servo amplifier, servomotor and regenerative resistor on
inflammable material. Direct installation on flammable material or near flammable ma
10、 SV1322 -SV1322(REAL MODE) Programming 手册
A - 2
! CAUTION
Install the Motion controller, servo amplifier, servomotor and regenerative resistor on
inflammable material. Direct installation on flammable material or near flammable ma
11、 SV1322 -SV1322 Programming 手册 (REAL MODE) [type Q173DQ172D]
2. For fire prevention
CAUTION
Install the Motion controller, servo amplifier, servomotor and regenerative resistor on
incombustible. Installing them directly or close to combustibles will
12、 -SV1322 Programming 手册 (Motion SFC) [type Q173HQ172H]
2. For fire prevention
! CAUTION
Install the Motion controller, servo amplifier, servomotor and regenerative resistor on inflammable
material. Direct installation on flammable materia