This manual confers no industrial property rights or any rights of any other kind,
nor does it confer any patent licenses. Mitsubishi Electric Corporation cannot be
held responsible for any problems involving industrial property rights which may
occur as a result of using the contents noted in this manual.
Warranty
Mitsubishi will not be held liable for damage caused by factors found not to be
the cause of Mitsubishi; opportunity loss or lost profits caused by faults in the
Mitsubishi products; damage, secondary damage, accident compensation
caused by special factors unpredictable by Mitsubishi; damages to products
other than Mitsubishi products; and to other duties.
For safe use
This product has been manufactured as a general-purpose part for general
industries, and has not been designed or manufactured to be incorporated in
a device or system used in purposes related to human life.
Before using the product for special purposes such as nuclear power, electric
power, aerospace, medicine or passenger movement vehicles, consult with
Mitsubishi Electric.
This product has been manufactured under strict quality control. However
when installing the product where major accidents or losses could occur if the
product fails, install appropriate backup or failsafe functions in the system.
•
•
•
HEAD OFFICE
HIMEJI WORKS
: TOKYO BUILDING, 2-7-3 MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310,
JAPAN
: 840, CHIYODA CHO, HIMEJI, JAPAN
• The grounding wire size should be AWG 14 (2 mm2).
• The grounding point should be close to the PLC, and all grounding wire should be
as short as possible.
4. Specification

DESIGN
PRECAUTIONS
• Provide a safety circuit on the outside of the PLC so that the whole system
operates to ensure the safety even when external power supply trouble or PLC
failure occurs.
Otherwise, malfunctions or output failures may result in an accident.
1) An emergency stop circuit, a protection circuit, an interlock circuit for opposite
movements, such as normal and reverse rotations, and an interlock circuit for
preventing damage to the machine at the upper and lower positioning limits
should be configured on the outside of the PLC.
2) When the PLC CPU detects an error, such as a watch dog timer error, during
self-diagnosis, all outputs are turned off. When an error that cannot be
detected by the PLC CPU occurs in an input/output control block, output con-
trol may be disabled.
Design external circuits and mechanisms to ensure safe operations of the
machine in such a case.
3) When some sort of error occurs in a relay, triac or transistor of the output unit/
block, output may be kept on or off.
For output signals that may lead to serious accidents, design external circuits
and mechanisms to ensure safe operations of the machine.
4.3 Power Supply Specifications
Items Specifications
Supply voltage 100 - 240V AC
Allowable supply voltage range 85 - 264V AC
Rated frequency 50/60Hz
Allowable momentary
power failure time
The allowable momentary power failure time
depends on the power supply used.
• 100V AC power supply system:
The operation is continued to the momentary
power failure for 10 or less ms.
• 200V AC power supply system:
The operation is continued to the momentary
power failure for 100 or less ms.
In-rush current
30A Max. 5 ms or less/100V AC
65A Max. 5 ms or less/200V AC
Power consumption 20W Max.
Output current
(Internal for
supply)
24V DC 0.3A*1
5V DC 1A*1