2.1.3 Procedure for connecting with the FX3U Series PLC
When connecting to an FX3U:
Before connections, turn off the power to the
PLC.
1) Remove the extension device connector
cover of the main unit.
2) Fold and insert the extension cable in the
corresponding connector as shown to the
right.
3) Reattach the extension device connector
cover on the main unit.
When connecting to an FX3UC:
When connecting the FX3U-ENET-L,
either the FX3UC-1PS-5V or FX2NC-
CNV-IF is required.
1) The connector cover (A) of the
FX3UC-1PS-5V is removed as
shown in the figure to the right.
The FX2NC-CNV-IF does not have a
connector cover.
2) Connect the extension cable as
shown to the right.
2)
1)
2)
3)
FX3UC-1PS-5V or
FX2NC-CNV-IF
Extension cable on
the right side
FX3UC-1PS-5V
Connector cover
(A)
so.
STARTUP AND
MAINTENANCE
PRECAUTIONS
• Do not disassemble or modify the unit.
Doing so may cause fire, equipment failures, or malfunctions.
• The unit case is made of resin. If dropped or subjected to strong impact, the unit
may be damaged.
• When this unit is installed or removed from the panel, make sure to externally cut
off all phases of the power supply. Failure to do so may cause malfunction or
failure of this unit.
DISPOSAL
PRECAUTIONS
• Please contact a certified electronic waste disposal company for the
environmentally safe recycling and disposal of your device.
TRANSPORT AND
STORAGE PRECAUTIONS
• The product is a precision instrument. During transportation, avoid any impacts.
Failure to do so may cause failures in the product.
After transportation, verify the operations of the product.
*1 Length between a hub and a node.
*2 Refer to the FX3U-ENET-L User's Manual
specifications.
*3 It is not possible to send an attached file and main
3.1 Applicable PLC
The version number can be checked by reading the las
*1 An FX2NC-CNV-IF or FX3UC-1PS-5V is necessar
with the FX3UC PLC.
3.2 Related software
*1 To use FX Configurator-EN-L, either of the followin
the procedure.
External dimensions
90(H) × 55(W) × 8
3.55"(H) × 2.17"(W
MASS (Weight) 0.3kg(0.66lbs)
Number of connectable units to
the main unit
1
Model name Appli
FX3U Series PLC
Ver. 2.21 and later
Only one FX3U-ENET-L un
unit.
FX3UC Series PLC*1
Ver. 2.21 and later
Only one FX3U-ENET-L un
unit.
Model name
FX Configurator-EN-L*1 Ver. 1.00 and lat
GX Developer Ver. 8.88S and l