广州菱控|三菱
当前位置:首页 >> 资料下载 >> 三菱 >> 伺服系统 >> 三菱-CL1X2 三菱-CL1X2-D1D3S 用户 手册
三菱-CL1X2 三菱-CL1X2-D1D3S 用户 手册
所属类别:三菱 >> 伺服系统
资料介绍:

Wiring
External wiring
e input terminals of the CL1X2-D1D3S operate while using the power
plied from the interface.
en connecting a sensor to the input terminal, use a sensor of the NPN
n collector transistor type.
ut wiring
Connection to sensor
hen using a two-wire type sensor y When using a three-wire type sensor
eplace * in the figure with the used input No.
es:
Bleeder resistor
When connecting a two-wire type sensor or input equipment having
parallel resistor, select a sensor or equipment whose leakage current is
1.7mA or less.
If the leakage current is more than 1.7mA, connect a bleeder resistor
obtained in the following calculation formula.
24G
DA
DB
+24V
DC DC
R
X1
X0
0.5A
+24V
24G
R
CL1X2-D1D3S
Isolation
Flat cable
dedicated
to CC-Link/LT
Flat cable
for I/O
Internal
circuit
. . .
Bleeder resistor *1
Connected to +24 V
cable
Sensor (NPN) Sensor (NPN)
X *
24G
X *
24G
Connected to +24 V
cable
Detection
circuit
Detection
circuit
5. Specifications
5.1 General specifications
Notes:
*1 The module cannot be used in an environment pressurized above the
atmospheric pressure which can be generated around the altitude of 0 m. If the
module is used in such an environment, it may fail.
Item Specification
Ambient
working
temperature
0 to 55°C (32 to 131°F)
Ambient storage
temperature
-25 to 75°C (-13 to 167°F)
Ambient
operating
humidity
5 to 95%RH: Dew condensation shall not be considered.
Ambient storage
humidity
5 to 95%RH: Dew condensation shall not be considered.
Vibration
resistance
When intermittent vibration is present
Number of times of
sweep
Frequency Acceleration Half amplitude
10 times in each of
X, Y and Z directions
(for 80 min)
10 to 57Hz − 0.075mm
57 to 150Hz 9.8m/s2 −
When continuous vibration is present
Frequency Acceleration Half amplitude
10 to 57Hz − 0.035mm
57 to 150Hz 4.9m/s2 −
Impact
resistance
147 m/s2, 3 times in each of X, Y and Z directions
Operating
atmosphere
Corrosive gas shall not be present.
Operating
altitude
2,000m(6561'8") or less (*1)
Installation
place
Inside control panel (*2)
Over-voltage
category
ΙΙ or less (*3)
Degree of
contamination
2 or less (*4)
5.2 Input specificatio
5.3 Performance spe
Item
Input method
Number of inputs
Isolation method
Rated input voltage
Rated input current
Operating voltage range
Max. simultaneous ON
input points
ON voltage/ON current
OFF voltage/OFF current
Input resistance
Response
time
OFF→O
ON→OF
Common wiring method
Item
Module
power
supply
Vol tage
Current
consumption
Initial current
Max. allowabl
momentary pow
failure period
Number of stations
occupied
Noise durability
Withstand voltage
Isolation resistance
立即下载     
相关下载